Carvings

Because the quality of the engraving works will be affected by the type of wood, the water content of the wood, the processing parameters, the parameters of the tool and the material of the tool." A three-edge titanium steel straight slot cutter with good chip removal performance and a carbide double-edge straight slot cutter with small friction coefficient were selected for processing. The motor speed was adjusted to 21000r/min. First, the three-edge titanium steel straight slot milling cutter is roughed, the machining depth is 3mm, and the feed speed of the plane milling is 60 mm/s; Then use a double-edged straight slot sharp knife with an Angle of 30° and a knife tip of 1.5 mm to trim the outline; Finally, the Angle of 15° and the tip of the knife 0.4 mm were selected for finishing. Comparing ash wood, Sabili wood, camphor wood and gold teak carving works, it is found that gold teak carving has clear outline, no burrs, no cracks and good color effect. Finally, golden teak was selected for batch processing, as shown in the figure.